gvtcx

Supply and Installation of a PEM Electrolyser Test System

UNIVERSITY OF BIRMINGHAM Published 22 Dec 2021 Find a Tender

key details

Value£326,429
Statusactive
Category (CPV) 38000000
RegionWest Midlands
Deadline26 Jan 2022
Procedureopen
OCIDocds-h6vhtk-03047f

description

The University of Birmingham invites tenders for supply of a PEM electrolyser test system. The system will be used to test membrane electrode assemblies with an active area up to 50 cm2 to optimise their fabrication process based on a granted project. A cathode operating pressure of 3.5 MPa or higher is required with the maximum current no less than 125 A.

The test system also needs to be able to conduct both

electrochemical impedance spectroscopy and cyclic voltammetry analysis, as well as including a H2 concentration

sensor at the air side to monitor the hydrogen penetration rate and safety. Also, this system should incorporate a water supply system, and the PC with the control software for conducting the required operation.

This project may be funded by the European Regional Development Fund (ERDF) or

European Structural and Investment Fund (ESIF) or

Research Councils UK (RCUK), the strategic partnership of the UK's seven Research Councils.

notice history

1 notice published against this procurement.

PublishedTypeRegimeNotice
22 Dec 2021 Contract notice (F02) Earlier regulations 032008-2021

more from UNIVERSITY OF BIRMINGHAM

all contracts from this buyer →

similar contracts awarded

Other awarded contracts in the same category. Useful for seeing who normally wins this kind of work, and at what value.

source

Published on Find a Tender. Contact details for named individuals are not reproduced on this site.